Filter
Top Products
17
Soak the tip in hot water before using •
the pin on the cleaning tool to unblock.
Replace the tip back onto the steam
wand and secure with the cleaning tool.
Cleaning The Filters, Filter Holder And
Brewing Head
The stainless steel filters and filter •
holder should be rinsed under water
directly after use to remove all coffee
particles. Should the fine holes in the
filters become blocked; the fine pin on
the cleaning tol can be used to clear the
holes.
The group head interior should be wiped •
with a damp cloth to remove any ground
coffee particles.
Periodically run water through the •
machine with the filter holder in place,
but without any ground coffee, to rinse
out any residual coffee particles.
CARE AND CLEANING
Before cleaning, ensure the ‘Selector
Control’ is in the ‘STANDBY’ position and
press the ‘POWER’ button ‘Off’, then
unplug the power cord and allow the unit
to cool.
Cleaning The Steam Wand And
Froth Enhancer
The steam wand and froth enhancer •
should always be cleaned after frothing
milk.
If attached, remove the froth enhancer •
and rinse under warm tap water.
Wipe the steam wand with a damp cloth, •
and then with the steam wand directed
back into the drip tray, briefly set the
‘SELECTOR CONTROL’ to the ‘STEAM’
position. This will clear any remaining milk
from inside the steam wand.
If the steam wand becomes blocked, •
wait for the machine to cool before using
the ‘CLEANING TOOL’ to unblock the
opening.
NOTE:
The 'Cleaning Tool' is located at the front
of the machine under the left of the group
head.
If the steam wand continues to be •
blocked, the tip of the steam wand can
be removed by using the spanner in the
middle of the cleaning tool.