Filter
Top Products
18
Diluted
Solution
(for softer water)
1 part white vinegar
2 parts cold tap water
Concentrated
Solution
(for harder water)
1 part white vinegar
1 part cold tap water
Ensure the ‘SELECTOR CONTROL’ is in •
the ‘STANDBY’ position, the ‘POWER’
button is in the ‘Off’ position and the
machine is unplugged.
Remove the filter holder and frothing •
attachment. Pour the mixture of white
vinegar and water into the water tank.
Press the ‘POWER’ button to the ‘On’ •
position and turn the ‘SELECTOR
CONTROL’ to the ‘STANDBY’ position.
Place a large container under the group •
head, and steam wand.
When the brewing temperature has •
been reached the red ‘HEATING’ light
will switch off. Turn the ‘SELECTOR
CONTROL’ to the ‘ESPRESSO’ position
to commence pour.
Once half the mixture of white vinegar •
and water has run through the group
head turn the ‘SELECTOR CONTROL’ to
the ‘STANDBY’ position.
Set the ‘SELECTOR CONTROL’ to the •
‘STEAM’ position and allow the remaining
solution to run through the steam wand.
When the solution has run through, set
the ‘SELECTOR CONTROL’ back to
‘STANDBY’ position.
After decalcifying, remove the water tank •
and rinse thoroughly then re-fill with fresh
cold water. To rinse the machine, repeat
previous steps.
NOTE:
Do not use any other decalcifying agents,
other than vinegar.
CARE AND CLEANING
Cleaning The Housing / Cup
Warming Tray
The outer housing can be wiped with a •
soft, damp cloth (do not use abrasive
agents or cloths which can scratch
the surfaces).
WARNING: DO NOT IMMERSE
CORD, PLUG OR APPLIANCE IN
WATER OR ANY OTHER LIQUID.
Cleaning The Drip Tray
The drip tray should be removed, •
emptied and cleaned at regular intervals,
particularly when the drip tray full
indicator is showing ‘Empty Me!
Remove the stainless steel grid and pull •
the ‘Empty Me!’ full indicator upwards
to dislodge from the drip tray. Wash with
warm soapy water, using a non-abrasive
washing liquid, rinse and dry thoroughly.
NOTE:
Make sure to wipe off any excess coffee
from the rim of the filter to ensure a proper
seal is achieved under the group head.
WARNING: DO NOT IMMERSE
CORD, PLUG OR APPLIANCE IN
WATER OR ANY OTHER LIQUID.
Decalcifying The Machine
After regular use, hard water can cause •
mineral build up in and on many of the
inner functioning components, reducing
the brewing flow, power of the machine,
and affecting the quality of coffee.
We advise decalcifying the machine on a •
regular basis (every 2-3 months) using a
mixture of white vinegar and water.
Follow the instructions provided or use •
the following as a guide:
!
!