Filter
Top Products
CARE AND CLEANING
25
Cleaning
CLEANING THE STEAM WAND AND
FROTHING ATTACHMENT
• The Steam Wand and Frothing
Attachment should always be cleaned
after frothing milk.
• Remove the Frothing Attachment and
rinse in warm tap water. Ensure the two
fine steam holes on either end of the
Frothing Attachment are clear. Use the
pin on the Cleaning Tool to unblock
these holes.
• Wipe the Steam Wand with a damp
cloth, then with the Steam Wand
directed back into the drip tray, briefly
set the Selector Control to the ‘Steam’
position and press the Hot Water button.
This will clear any remaining milk from
inside the Steam Wand.
• Ensure the Selector Control is in the
‘Standby’ position. Press the ‘ON/OFF’
button to ‘OFF’, switch off at the power
outlet, unplug the power cord and allow
the machine to cool.
• If the Steam Wand remains blocked, use
the pin on the Cleaning Tool to clear the
opening.
• If the Steam Wand continues to be
blocked, the tip of the Steam Wand can
be removed
by using the spanner in the middle of the
Cleaning Tool.
CARE AND CLEANING
24
BR6659_800ESXL_Book_US.qxp 15/2/06 4:54 PM Page 24