Filter
Top Products
12
CARE AND CLEANING
NOTE: Before cleaning, always switch off and unplug the appliance from the mains
supply.
• For easy cleaning - immediately after each use rinse removable parts under
running water (to remove wet pulp). Allow parts to air dry.
• After disassembling the unit, all removable parts may be washed in hot soapy
water.
• Wipe the Motor Base with a soft, damp cloth.
WARNING! The Motor Base must never be immersed in water or any other liquid.
• Before washing Collector Jug, remove from attachment and rinse under running
water.
• For consistent juicing results always ensure that the stainless steel filter basket is
thoroughly cleaned using a nylon brush. Whilst using a nylon brush, hold the
Extractor Filter under running water and brush from the inside of the basket to outer
rim. After cleaning the Extractor Filter, hold it up towards a light to ensure the fine
mesh holes are not blocked. If the holes are blocked soak the Extractor Filter in
hot water with 10% lemon juice to loosen the blocked holes. Alternatively wash the
filter basket in the dishwasher.
• Always treat the Extractor Filter with care as it can be easily damaged.
• Some vegetables, such as carrots, may cause discolouration of the plastic. This
will be reduced by washing immediately after use.
• To remove this discolouration, use a suitable, non-abrasive cleaner on a soft cloth.
• Never use steel wool, scouring pads or abrasive cleaners which may damage the
product and leave scratches which can harbour dirt and germs.
• Dismantle the Professional Juicer, wash the components in warm soapy water and
dry thoroughly.
NOTE: To assist with cleaning, soak the Extractor Filter in hot soapy water for
approximately 10 minutes immediately after juicing is completed. If pulp is left to
dry on the filter it may clog the fine pores of the filter mesh thereby lessening the
effectiveness of the Juicer.
JE16_New.pmd 3/24/2006, 4:17 PM12