Filter
Top Products
- 10 -
16. REINSTALL THE BLOWER (SINGLE BLOWER MODEL, HORIZONTAL DISCHARGE ONLY)
The single blower power pack is factory shipped for a
vertical discharge installation. For a horizontal
discharge installation, the blower must be flipped.
Using a 5/16” socket, or a Phillips no. 2 or a
Robertson no. 2 screwdriver, secure the blower to the
inner back of the power pack with all blower mounting
screws (previously removed in step 13).
HD0371
LEFT SIDE MOUNTING
SCREW LOCATION
HD0372
RIGHT SIDE
MOUNTING SCREW
LOCATION
17. REINSTALL FRONT PANEL AND WIRING COVER
CAUTION
Take care not to pinch wiring when reinstalling the front panel and the wiring cover.
Carefully reassemble the front panel to the power pack by aligning the tabs with their corresponding slot. Using a Robertson
no. 2 or a Phillips no. 2 screwdriver, secure the front panel to the power pack using its both retaining screws (A) previously
removed in step 8. Reassemble the wiring cover using its both retaining screws (B) previously removed in step 8. Plug the
motor(s) (one or two, depending on models) to the front panel.
HO0138
HD0365
B
A
HE01105
18. CONNECT WIRING (ALL MODELS)
WARNING
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service
disconnecting means to prevent power from being switched on accidentally.
!
Position the power pack below the installed custom hood. Insert the house wiring cable through the wire clamp previously
installed in step 9. Tighten the wire clamp to secure the cable.