Filter
Top Products
Lighting and Start-Up Instructions
The Li
g
htin
g
and Start-Up Instructions are located on
the top portion of the interior door liner.
Refer to Fi
g
ure 8 for location of the operatin
g
controls.
Notice: When warm humid weather conditions are ob-
served, operate the refrigerator on either AC or
DC electric for a minimum of five (5) minutes
before attempting to follow the Start-Up Instruc-
tions for Gas operation.
AC Operation
1. Press mode selection button
(
C
)
.
2. Set the thermostat
(
B
)
to the coldest
(
maximum
)
settin
g
. Allow to operate at maximum settin
g
for
6 to 8 hours before settin
g
to mid ran
g
e.
DC Operation
1. Press mode selection button
(
D
)
. There is no
need to set thermostat to an
y
settin
g
. The DC
operation is a continuous run
(
no thermostat
control
)
mode.
Gas Operation
1. Set thermostat
(
B
)
to the start settin
g
.
2. Press mode selector button
(
E
)
. I
g
nition spark
will be present at the burner.
3. Push and hold the safet
y
valve button
(
A
)
until
the indicator lamp
(
G
)
g
lows stead
y
. Continue
to hold the safet
y
valve button in for 15 seconds
and then release. The indicator lamp should
remain a stead
y
g
low. If the lamp turns off,
repeat this step.
Notice: On initial start-up, it may take longer for
the burner to light because of air being
purged from the gas supply line.
Do not hold gas valve in more than 30 seconds. If the
flame is not indicated within this time, press selector
switch (F), wait 2 minutes, and retry. Continuing to hold
the gas valve in will cause gas to build up in the burner
area and can result in an explosion which can cause
property damage or severe personal injury.
1. Set thermostat to desired temperature settin
g
.
Shut-Down: All Modes
Press mode selector button
(
F
)
. This will interrupt all AC
and DC power and stop operation of the refri
g
erator.
WARNING
A
B
C
D
E
F
G
Fi
g
ure 8
6