Filter
Top Products
Page 21
REVIEW RECIPES/MODIFY RECIPES/SET UP NO NAME
COFFEE FLAVORS:
This function has three parts. It allows the operator
to view the brew settings for the various beverage
names programmed into the brewer.
It also allows the operator to modify (change) any
of the BREW VOLUMES, DILUTION VOLUMES, PULSE
BREW TIMES, PRE-INFUSION TIMES and DRIP-OUT
TIMES for a particular beverage name programmed
into the brewer.
Finally, this function is used to set up the NO NAME
beverage BREW VOLUMES, DILUTION PERCENTAGES,
PULSE BREW TIMES, PRE-INFUSION TIMES and DRIP-
OUT TIMES.
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
(RECIPE NAME)
MODIFY NEXT
THAT WAS THE
LAST RECIPE
NO-NAME
MODIFY NEXT
REVIEW RECIPES?
NO YES
EXIT TO
NEXT FUNCTION
SCREEN
SCROLLS THROUGH ALL
BREW SETTINGS FOR
NO-NAME BEVERAGE
SCROLLS THROUGH ALL
BREW SETTINGS FOR ANY
OTHER BEVERAGE NAMES
STORED IN BREWER'S MEMORY
WHEN THE LAST BEVERAGE NAME
IN THE BREWER'S MEMORY IS
DISPLAYED, PRESSING NEXT
WILL EXIT AND THE DISPLAY
WILL THEN READ:
ADVANCES TO ALL OTHER
BEVERAGE NAMES
PROGRAMMED IN THE
BREWER'S MEMORY
P3212
Procedure for reviewing recipes:
1. Press and hold the ® pad until the display reads
SET NEW RECIPES. Release the ®. Press the ®
until the display reads REVIEW RECIPES.
2. Press YES to proceed. The display should now
read NO NAME, along with MODIFY and NEXT.
3. To advance to the next beverage name, press
NEXT.
4. To exit, press NEXT until the display reads THAT
WAS THE LAST RECIPE.
5. After 5 seconds, the display will return to the
REVIEW RECIPES screen. Press and release NO
to advance to the next function screen, or press
the "ON/OFF/LOWER" pad located on the front
switch panel to exit the programming mode and
return to the MAIN SCREEN.
37467 110904