Filter
Top Products
Page 27
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
Setting Pulse Brew - ENTER TIMES:
NOTE: No water should flow from the brewer during
this set-up process.
1. This display should read 1ST ON TIME X:XX.
Choose the batch size to be set by pressing the
pad next to the indicator light on the front panel.
The batch size indicator selected will be flashing.
2. Adjust the 1ST ON TIME using (-) and (+). When
finished, press DONE. (a)
3. The display will now read OFF TIME X:XX. Adjust
the OFF TIME using (-) and (+). When finished,
press DONE.(b)
4. The display will now read LAST ON TIME X:XX.
Adjust the LAST ON TIME using (-) and (+). When
finished, press DONE.(c)
5. The display will show the three times just entered
for that batch size. After a 5 second delay, the dis-
play will read BATCHES DONE?(d and e)
ENTER TIMES
RETURN TO
SET BY EXAMPLE
5 SEC. DELAY
SEE MODIFYING
PREINFUSION
OFF TIME X:XX
(-) DONE (+)
1ST ON TIME X:XX
(-) DONE (+)
LAST ON TIME X:XX
(-) DONE (+)
1ST OFF LAST
X:XX X:XX X:XX
BATCHES DONE?
NO YES
SET PREINFUSION?
NO YES
(a)
(b)
(c)
(d)
(e)
(f)
P3218
6. If other batch sizes need to be modified, press
NO. The display will then read SET BY EXAMPLE.
7. In that screen, press NO. The display should now
read ENTER TIMES.
8. Press YES in this screen, then press a different
batch size pad and repeat steps 2 through 4. Re-
peat until all the desired batch sizes are set for the
left side.
9. When finished press YES in BATCHES DONE?. The
display will then read SET PREINFUSION. Another
alternative is to press the "ON/OFF/LOWER" pad
located on the front panel of the brewer to exit
SET PULSE BREW and return to the MAIN
SCREEN.
NOTE: Pressing ® before reaching the final setting
screen exits the setup and retains the old values.
37467 110904