Filter
Top Products
Page 34
BREW COUNTERS
This function allows the operator to track the
number of brew cycles completed. There is one
resettable counter, and one life counter that is not
resettable.
EXIT TO
NEXT FUNCTION
SCREEN
COUNT 0
NEXT RESET
COUNT 0
NEXT
BREW COUNTERS?
NO YES
Procedures to view/reset the brew counters:
1. Press and hold the ® pad until the display reads
WARMER OFF. Release the ®. Press and release
the ® pad until the display reads BREW COUNTERS.
2. Pressing NO in this screen will advance to the next
function. Press YES to view the first brew counter.
This number represents the brew cycles initiated
since that counter was last reset.
3. To reset the resettable counter to zero press and
release RESET when viewing that particular
counter's screen.
4. To advance to the other counter, press and release
NEXT. This will advance to total brews (non-
resettable).
5. When finished, press NEXT until the display reads
BREW COUNTERS. Press and release NO to ad-
vance to the next function screen, or press the "ON/
OFF/LOWER" pad on the front switch panel to exit
the BREW COUNTERS function and return to the
MAIN SCREEN.
P3225
FUNNEL LOCKOUT?
NO DONE YES
Procedure to set funnel detect:
1. Press and hold the ® pad until the display reads
WARMER OFF. Release the ®. Press and release
the ® pad until the display reads FUNNEL LOCK-
OUT.
2. NO or YES should be flashing to indicate the
current setting.
3. Select YES to prevent brewing if a Smart Funnei is
not correctly situated in the rails. If this function
is activated and a brew cycle is attempted with the
funnel not properly situated, the display will read,
FUNNEL NOT IN PLACE, until one is in place.
4. Select NO to allow brewing without a Smart Funnel
in place. This is selected when brewing with a
funnel other than a Smart Funnel (a regular brew
funnel).
5. When finished, press and release DONE. This will
retain the changes, exit this function screen and
advance to the next. Another alternative is to press
the "ON/OFF/LOWER" pad located on the front
switch panel to exit the FUNNEL LOCKOUT and
return to the MAIN SCREEN.
P3226
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
FUNNEL LOCKOUT
This function allows the operator to prevent the
start of a brew cycle if a Smart Funnel is not positioned
correctly in the funnel rails.
37467 110904