Filter
Top Products
Page 28
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET PREINFUSION
This function allows the operator to set an initial
soaking of the grounds/tea and a delay time, before
the complete brew cycle starts.
Procedure for Modifying preinfusion times:
Range: On time - off to 4 minutes
Off time - off to 4 minutes for all batch sizes
NOTE: If the brewer is already in the SET PREINFUSION
screen, it is not necessary to follow steps 1 through 9
in this section, but proceed directly to step 10.
1. Press and hold the ® pad until the display reads
WARMER OFF. Release the ® pad. Press the ®
until the display reads REVIEW RECIPES.
2. Press YES to proceed. The display should now
read NO NAME, along with MODIFY and NEXT.
3. Press and release NEXT to advance to the desired
coffee name to be modified.
4. Press and release MODIFY. The display should
read BREW MI/M.
5. Press and release DONE. The display should read
BATCHES DONE?.
6. Press and release YES. The display should now
read % DILUTION.
7. Press and release DONE. The display should read
BATCHES DONE?.
8. Press and release YES. The display should now
read SET PULSE BREW.
9. Press and release NO. The display should now
read SET PREINFUSION.
10. Press YES to proceed. The display should now
read ON TIME and a batch light will be blinking.
11. Using (-) and (+), set the amount of time the brew
water will initially presoak the grounds for that
particular batch size.
12. When finished, press another batch size and re-
peat until all three batch sizes are set.
13. When finished, press DONE. The display should
now read OFF TIME and a batch light will be
blinking.
14. Using (-) and (+), set the amount of time the brew
cycle will delay (after the presoak cycle shuts off)
before resuming brewing.
15. When finished, press another batch size and re-
peat until all three batch sizes are set.
16. When finished, press DONE. The display will show
the ON and OFF TIMES that were entered for a
particular batch size.
17. After a 5 second delay, the display should read
BATCHES DONE?. If all batches are not complete,
press NO in order to return to SET PREINFUSION,
and repeat steps 10 through 14.
18. If all batches are done, press YES. This will
advance to the next function, SET DRIP TIME.
Another alternative is to press the "ON/OFF/LOWER"
pad located on the front panel of the brewer to exit
SET PULSE BREW and return to the MAIN SCREEN.
REVIEW RECIPES?
NO YES
SET PREINFUSION?
NO YES
BATCHES DONE?
NO YES
ON OFF
X:XX X:XX
OFF TIME X:XX
(-) DONE (+)
DRIP TIME X:XX
(-) DONE (+)
ON TIME X:XX
(-) DONE (+)
(RECIPE NAME)
MODIFY NEXT
THAT WAS THE
LAST RECIPE
NO-NAME
MODIFY NEXT
EXIT TO
NEXT FUNCTION
SCREEN
ADVANCES
TO NEXT
SCREEN
5 SEC. DELAY
PRESS
DONE
YES
DONE
YES
NO
SCREEN DISPLAYED
BREW OZ: XX.XX
BATCHES DONE?
% DILUTION XX.X
BATCHES DONE?
SET PULSE BREW?
ADVANCES TO ALL OTHER
RECIPE NAMES PROGRAMMED
IN THE BREWER'S MEMORY
WHEN THE LAST RECIPE NAME
IN THE BREWER'S MEMORY IS
DISPLAYED, PRESSING NEXT
WILL EXIT AND THE DISPLAY
WILL THEN READ:
SEE MODIFYING
DRIP TIMES, PAGE 25
P3219
37467 110904