Filter
Top Products
Hot Drink Center Set-Up Manual
6530006 17
March, 2001
II. Positioning the Merchandiser
You can position this merchandiser anywhere in a bank of machines. It can even
be placed on the end flush against a side wall. Be sure you leave enough room in
front of the merchandiser for the door to move freely.
BE SURE THE REAR OF THE MERCHANDISER IS AT LEAST 6
INCHES (15 cm) AWAY FROM THE WALL. THIS WILL ALLOW
WARM MOIST AIR TO BE VENTED OUT OF THE MACHINE'S INTE
-
RIOR.
WARNING
THIS MACHINE IS ONLY RATED FOR INSTALLATION IN AN
INDOOR LOCATION.
III. Connecting Everything
1. Connect the Merchandiser to the Water Supply:
a. You will need the following:
• A coil of copper tubing with outside diameter of 3/8 inch (9.5 mm) or
greater. The appropriate plastic tubing may be substituted. The tubing
must be long enough to reach from the water source to your machine with
enough left over to form a loop about 2 feet (60 cm) in diameter. This
will allow you to move the machine without straining the water line.
• A 3/8 inch (9.5 mm) flare fitting.
b. Connect the merchandiser to your water supply.
2. Connect the Merchandiser to the Electrical Power Supply:
Power inside the merchandiser is controlled by the main power switch, located
on the power panel.
a. Make sure the main power switch is OFF.
b. Connect the merchandiser’s power cord to your wall outlet.
IV. Final Mechanical Preparation
1. Level the Merchandiser:
a. Using a spirit level, adjust the front and rear leg levelers until the
machine is level from side to side and back to front.