Filter
Top Products
Basic Setup HDC II Programming Guide
6730018 11 July, 2003
SET DEX OPTIONS (DEX MODE ONLY)
1. Follow the steps in "Gain Access To The Supervisor Mode", PAGE 7.
2. Press , then until the display shows one of two resettable
bill validator totals transmitted to the DEX device:
- the value of bills in the stacker will be transmitted in a
cash format. For example: 200 for two dollars. (This is the default setting.)
- the value of bills in the stacker will be transmitted in a dol-
lar count format. For example: 2 for two dollars.
3. Press to switch between the two choices. Consult your DEX hand-
held supplier for the proper settings for your machine.
NOTE
If your bill count is incorrect, the CA304 setting may be
wrong. Try using the other setting.
4. Press until the display shows one of the following two date/time
options:
- the DEX device will transmit the date and time of the last
vend for each selection.
- OR -
- the DEX device will NOT transmit the date and time of the
last vend for each selection. (This is the default setting)
5. Press to switch between the two choices.
6. CONTINUE.