Filter
Top Products
HDC II Programming Guide Monetary Setup
July, 2003 16 6730018
2. Press until one of the following is displayed:
3. < -Accept any bill of value $X.XX or less, regardless of avail-
able change. Hold the last bill which meets or exceeds maximum price in
escrow. (This setting is normally used.)
- OR -
4. -Accept any bill of value $X.XX or less, regardless of avail-
able change. Immediately stack the last bill.
Example: If setting is and maximum price is $1.50. This
setting will immediately stack the second $1.00 bill inserted.
5. Press to display the desired choice.
6. The value of " " has two purposes:
a. The value of " " tells the machine how big a bill or coin to accept
even though there is not enough change in the coin mech to cover all
possible paybacks.
For example, enter 1.00. Therefore, the machine will take a dollar bill
or coin even though there is less than $1.00's worth of change. Entering
5.00 tells the machine to take a five even though there is less than
$5.00's worth of change, and so forth.
NOTE
This could cause a customer to be short-changed.
Entering 0.00 means that bills or coins not held in escrow or in a tube
will only be accepted if there is enough change to cover them.
b. The value of " " tells the machine how much the customer is allowed
to overbuy a product. The customer will be short-changed when an
overbuy occurs. Example:
For a value of $0.25: if there is no change in the machine and the cus-
tomer inserts a $1.00 bill. The customer can purchase a product for
$0.75 even though the change cannot be paid back. The customer will
be short-changed. Normally a purchase will not be approved unless all
change can be paid.
Entering 0.00 means that the vend will only be approved when the cor-
rect change can be returned (overbuy disabled).