Filter
Top Products
HDC II Programming Guide Check the Setup
July, 2003 52 6730018
VIEW CUP SIZES ASSIGNED TO SELECTIONS
1. Press , then press until the display shows - - - - - -.
This example shows that regular size cups are assigned to selections C & G.
NOTE
Press to display the remaining selections: - - - - - - -
NOTE
If you have only one cup size in your machine, you will not see
the next display.
2. Press . The display shows - - . This example shows that
large size cups are assigned to selections A thru C and F thru H.
NOTE
Press to display the remaining selections: - - - - - - -
3. CONTINUE.
PAYOUT COINS
1. Press . If a dumb mech was selected, the display shows ; if
an MDB mech was selected the display shows .
2. Press . A dumb mech pays out one Nickel; an MDB mech pays a
coin from tube 1. Press . A dumb mech pays out one Dime; an
MDB mech pays a coin from tube 2. Press . A dumb mech pays out
one Quarter; an MDB mech pays a coin from tube 3.
3. To continuously pay out coins, hold down the appropriate key.
4. CONTINUE.