Filter
Top Products
There are notches (C) on opposite sides of the interior of the hub. These
fit over ridges on the sides of the plastic blade sheath.
Pick up the blade ring by its hub holding ribs (grips) and line up the
notches in the interior of the blade ring hub with the ridges on the sides
of the plastic blade sheath. Let the blade ring slide down to the bottom
of the plastic blade sheath. The lower blade should almost touch the
bottom of the prep bowl.
Lift the prep bowl, holding it firmly from the bottom. Pick up the blader
ing by its hub holding ribs (grips) and turn it very slightly clockwise.
This locks it in place on the plastic blade sheath and prevents it from
sliding up during processing.
3. Connect the Smart Stick
®
Hand
Blender motor body to the top of the
chopper/grinder attachment cover.
Align the spline in the chopper/grinder
cover’s drive shaft with the ribbed
opening on the underside of the motor
body. When aligned properly, slide the
two pieces together until you feel and
hear a slight click. It may be helpful to
press the rubber release button when
sliding these pieces together.
4. With the hand blender in place,
locate the chopper/grinder cover
and place it on top of the prep bowl.
a. Be sure that the 3 ridges at the top
of the blade assembly line up
with the 3-arm propeller gear in the underside of the chopper/
grinder cover, and that the cover is seated all around the top of the
prep bowl.
b. To properly seat the cover, you must line up the three molded
pins from the cover with the 3 slots at the top of the prep bowl.
Rotate cover counterclockwise to secure it to the prep bowl.
Rotate the cover until the pins are in the far left position in
the slots.
10
5. Plug the power cord of the Smart Stick
®
Hand Blender into an
electrical outlet.
6. Place one hand on the cover of the chopper/grinder attachment,
while gripping the Smart Stick
®
Hand Blender motor body handle
with the other. Press the ON/OFF button with your fingers to start
the motor and run the chopper/grinder.
To turn the unit off, remove your fingers from the ON/OFF button.
7. WHEN THE BLADE STOPS MOVING, unplug the Smart Stick
®
Hand
Blender, remove the motor body from the chopper/grinder cover, and
remove the cover from the prep bowl.
WHISK ATTACHMENT
1. Align the end of the whisk with the small opening of
the whisk gearbox.
2. Push end into opening until it locks into position.
3. Align the motor body with the assembled whisk
attachment and slide the pieces together until
you hear and feel the pieces click together.
It may be helpful to press the release button
when assembling.
11
3.
Motor
Body Bottom and
Chopper/Grinder
Cover Top View
4a.
4.
Inside View of
Prep Bowl
Inside View of
Chopper/Grinder
Cover
4b.
C.
NOTCH
CSB-77C_IB_BILINGUAL 11/2/04 4:00 PM Page 10