Filter
Top Products
Us er I ns tructions
9
ENERGY SAVING TIPS
• Always try to run the dishwasher fully loaded.
• Do not wash the dishes in running water.
• Use the washing program that is most appropriate for each type of load.
• Do not carry out any preliminary rinsing.
• If available, connect the dishwasher to a hot water supply up to 140°F.
• When possible, disable the drying cycle and leave the door open at the end of the washing
cycle. The residual air and heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using
excessive amounts of detergent and to save on electricity, observe the following:
• Separate the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures.
• Do not pour the detergent directly on the dishes.
If it is necessary to open dishwasher door during the washing cycle, there will be a one (1) minute
delay before the program can be resumed. After correctly closing the door, the washing program will
start again from where it was interrupted. This operation may negatively affective the progress of the
washing cycle.
REMOVING DISHES
At the end of the washing program (the end of the washing program is signalled by a short
intermittent beep and the appearance of “
P0” on the display), wait at least twenty (20) minutes before
removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket
from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then
the upper basket.
SLIDING FACING PANEL (PEEKABOO FEATURE)
This dishwasher is equipped with a front display carrying the same information as the top control
panel. A system which moves the facing panel allows this display to be revealed when the dishwasher
door is closed; to do this follow the instructions in the moving the facing panel point. While the
program is in progress, the display shows the time left before it ends (hours alternating with minutes),
and the symbols described in page 5 “Description of the Controls” and any error warnings E2, E3,
. . .E6 also appear.The LUMINOUS LOGO remains off throughout the cycle and illuminates when it
ends.
LUMINOUS LOGO FRONT DISPLAY