Filter
Top Products
8
Us er I ns tructions
WASHING PROGRAMS
The dishwasher is equipped with a control panel and an information display, described in on page 5.
“Description of the controls”, from which it is possible to carry out all the power switch-on, switch-off
and programming operations.
Before starting a washing program make sure that:
• The water supply tap is open.
• The correct amount of detergent has been added to the dispenser.
• The baskets have been correctly loaded.
• The spray arms are able to rotate freely and without obstruction.
• The dishwasher door is securely closed.
HALF LOAD WASH
This function is especially suitable for loads up to six (6) place settings and allows saving of water and
electricity. It is controlled by the half load button (6) allows washing in the upper basket only.
IMPORTANT: At the end of the program remember to deactivate the function to ensure the next
wash is not also carried out in half load mode by mistake.
CAUTION: A cutlery basket can be placed in the upper basket, while the lower basket must be
left empty
.There is no point in loading dishes and cutlery in the lower baskets, since the
jet of water will only reach the upper basket.
EXIT PROGRAM
To exit the program being carried out, after opening the door select program “P0”. When the door is
closed the dishwasher will skip to the end of the program.
MODIFYING PROGRAM
To modify the current program, after opening the door select the new program. When the door is
closed the dishwasher will start the new program automatically.
DELAYING PROGRAM
The start of the washing program can be delayed from a minimum of 1 hour to a maximum of 9 hours;
this allows you to operate the dishwasher at the time of day of your choice. When the delayed start
button (3) is pressed, the display (7) will show first the duration of the program set and then the
number of hours (9,8,....1) of delay with which it is to be started.
The number of hours will disappear automatically if the keypad is not used for five (5) seconds or if
any other button except the delayed start button (3) is pressed. When the door is closed the
dishwasher will perform a pre-wash, after which the program delay set previously will start. To check
the time left before the program starts, simply press the corresponding button once.