Filter
Top Products
Care and Cleaning for Your Splash Guard
1) Wash by hand with warm water and mild deter-
gent, and then rinse and dry thoroughly.
6) To remove the splash guard, raise the mixer head
according to direction 1. Once the mixer head
has been raised and is locked into place, slide the
splash guard down.
Assembling Your Splash Guard (con’t)
STAINLESS STEEL BOWL
(Model 34655: 7-Quart)
(Model 34654: 5-Quart)
Assembling Your Bowl
2) Place the stainless steel bowl on the base and
align the two grooves on the base of the bowl
with the two notches on the base of the stand
mixer. Once in position, turn the bowl clockwise
until it locks into place. Figure 1.
3) Turn the head-lift lever counterclockwise to
unlock the mixer head. Once unlocked, lower
the mixer head until it locks into position. If the
mixer head fails to lock into place, check the
bowl to make sure that it is properly positioned.
1) Turn the head-lift lever on
your stand mixer counter-
clockwise and the mixer head
will pop up. Raise the mixer
head until it locks into place.