Filter
Top Products
9
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to the
value indicated on the rating plate on the bottom of the ap-
pliance.
Connecttheappliancetoanecientlyearthedandcorrectly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Setting up the appliance
Please note!
• Coeehasbeenusedtofactorytesttheapplianceanditis
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• Youshouldcustomisewaterhardnessassoonaspossible
following the instructions in the section “Setting water
hardness” on page 19.
1. Plug the power cable connector into the socket at the back
of the appliance and connect the appliance to the mains
electricity supply (g. 1). Make sure the main switch at
the side of the appliance is pressed (g. 2).
You must rst choose the language (the languages scroll
through at intervals of about 3 seconds):
2. When “English” appears, press and hold the
button (g. 3) for a few seconds until “English set” is dis-
played.
Follow the instructions indicated on the appliance display:
3. “FILL TANK”: remove the water tank (g. 4), open the lid
(g. 5), ll to the MAX line with fresh water (g. 6), re-
place the lid and put the tank back in the appliance.
4. “INSERT WATER SPOUT”: Check that the hot water spout is
inserted on the nozzle and place a container with a mini-
mum capacity of 100 ml underneath (g. 7).
5. “Water delivery Press OK” is displayed;
6. Press the button to conrm (g. 3). The appli-
ance delivers water from the spout then goes o auto-
matically.
The coee machine is now ready for normal use.
Please note!
• Whensettinguptheappliance,youneedtomake4/5
cups of coee or 4/5 cappuccinos before the appliance
starts to give satisfactory results.
• Toenjoyyourcoeeevenmoreandimprovetheperform-
ance of your appliance, we recommend installing a water
softener lter as described in the section “WATER SOFTEN-
ER FILTER” (page 19). If your model is not provided with
a lter, you can request one from De’Longhi Customer
Services.
TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch is
pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath. Avoid contact with
splashes of water.
• Toturntheapplianceon,presstheON-STANDBY
button (g. 8). The message “Heating up, Please wait” is
displayed.
After heating, the message “RINSING” is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coee appears.
TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts.
Avoid contact with splashes of water.
To turn the appliance o, press the ON-STANDBY but-
ton (g. 8). The appliance performs a rinse cycle then goes o
(stand-by).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
• rstturntheapplianceobypressingtheON-STANDBY
button (g. 8).
• releasethemainswitchatthesideoftheappliance(g.
2).
Important!
Never press the main switch while the appliance is on.