Filter
Top Products
20
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK
Insucientwaterinthetank. Fill the tank with water and/or insert it correctly, pushing it
as far as it will go until it clicks into place.
EMPTY GROUNDS CONTAINER
The grounds container (A18) is full.
Empty the grounds container and drip tray, clean and replace
(g. 29).
Important: when removing the drip tray, the grounds contai-
ner MUST be emptied, even if it contains few grounds.
If this is not done, when you make the next coees, the
grounds container may ll up more than expected and clog
the machine.
GROUND TOO FINE
ADJUST MILL
The grinding is too ne and the coee is delivered too slowly
or not at all.
Repeat coee delivery and turn the grinding adjustment
dial (g. 13) one click clockwise towards “7” while the coee
mill is in operation.
If after making at least 2 coees delivery is still too slow,
repeat the correction procedure, turning the grinding
adjustment dial another click until delivery is correct (see
the section “Adjusting the coee mill” on page 13).
INSERT GROUNDS CONTAINER
After cleaning, the grounds container has not been repla-
ced.
Remove the drip tray and insert the grounds container.
ADD PRE-GROUND COFFEE
The “pre-ground coee” function has been selected without
placing any pre-ground coee in the funnel.
Place pre-ground coee in the funnel or deselect the “pre-
ground” function (g. 18).
DESCALE
The machine must be descaled. The descaling procedure described in the section “Descaling”
needs to be performed as soon as possible (page 18).
REDUCE COFFEE AMOUNT
Too much coee has been used.
Select a milder taste by pressing the aroma selection
button (g. 10) or reduce the quantity of pre-ground coee.
FILL BEANS CONTAINER
The coee beans have run out. Fill the beans container (g. 14).
The pre-ground coee funnel is clogged. Empty the funnel with the help of a brush as described in the
section “Cleaning the pre-ground coee funnel”.
INSERT INFUSER ASSEMBLY
The infuser has not been replaced after cleaning. Insert the infuser as described in the section “Cleaning the
infuser”.
INSERT TANK
The tank is not correctly in place.
Insert the tank correctly and press as far as it will go.
GENERAL ALARM
The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in
the section “Cleaning”. If the message is still displayed after
cleaning, contact customer services.
WATER CIRCUIT EMPTY FILL
WATER CIRCUIT
Water delivery
PRESS OK
The water circuit is empty Press OK to deliver water from the spout (A11) until it ows
out normally.
REPLACE FILTER
The water softener lter is exhausted. Replace the lter or remove it as described in the section
“Water softener lter”.
TURN DIAL TO CLEAN
Milk has been delivered recently and the tubes inside the
milk container must be cleaned.
Turn the froth adjustment dial to CLEAN.
INSERT WATER SPOUT
The water spout is not inserted or is inserted incorrectly. Insert the water spout (D5) as far as it will go.
INSERT MILK CONTAINER
The milk container is not inserted correctly. Insert the milk container (g. 23) as far as it will go.
DESCALE
Descaling is necessary. See par. “DESCALING”.
REPLACE FILTER
Replace water lter. See par. “Replace water lter”.