DeLonghi ETAM36.365 Coffeemaker User Manual


  Open as PDF
of 22
 
13
- 1 cup, if you want 1 coee (g. 15);
- 2 cups if you want 2 coees (g. 17).
3. Lower the spout as near as possible to the cups (g. 16).
This makes a creamier coee .
4. Press the button corresponding to the number of coees
required (1 cup or 2 cups ).
5. Preparation begins. The amount of coee selected is dis-
played together with a progress bar which gradually lls
as preparation progresses.
Please note:
• Whilethemachineismakingcoee,deliverycanbein-
terrupted at any moment by pressing one of the delivery
buttons.
• Attheendofdelivery,toincreasethequantityofcoeein
the cup, just press and hold (within 3 seconds) one of the
coee buttons ( or ).
Once the coee has been made, the appliance is ready to be
used again.
Please note!
• Variousalarmmessagescouldbedisplayedwhileusing
the machine (FILL TANK, EMPTY GROUNDS CONTAINER,
etc.). Their meaning is explained in the section “Displayed
messages” (page 21).
• Forhottercoee,seethesection“Tipsforahottercoee”
(page 13).
• Ifthecoeeisdeliveredadropatatime,tooweakandnot
creamy enough or too cold, read the tips in the “Trouble-
shooting” section on page 22.
Making coee using pre-ground coee
Important!
• Neveraddpre-groundcoeewhenthemachineisoorit
could spread through the inside of the machine and dirty
it. This could damage the appliance.
• Neverusemorethanonelevelmeasureasitcoulddirty
the inside of the machine or block the funnel.
Please note!
If you use pre-ground coee, you can only make one cup
of coee at a time.
1. Press the aroma selection button (g. 10) until
“Pre-ground” is displayed.
2. Open the beans container lid, then open and raise the pre-
ground coee funnel lid.
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coee (g. 18).
4. Place a cup under the coee spouts.
5. Press the 1 cup button (g. 15).
6. Preparation begins. The amount of coee selected is dis-
played together with a progress bar which gradually lls
as preparation progresses.
Please note!
If “Energy saving” mode is active, you may have to wait a few
seconds before the rst coee is delivered.
MAKING MILK BASED DRINKS
Please note!
• Toavoidproducingmilkwithpoorfrothorlargebubbles,
always clean the milk container lid and hot water nozzle
as described in the section “Cleaning the milk container”
on pages 15 and 18.
Filling and attaching the milk container
1. Remove the lid by pressing the release button C4 and at
the same time lifting the lid upwards (g. 19);
2. Fillthemilkcontainerwithasucientquantityofmilk,
not exceeding the MAX level marked on the container (g.
20). Each mark on the side of the container corresponds
to about 100 ml of milk.
Please note!
• Foradensermoreevenfroth,youmustuseskimmedor
partially skimmed milk at refrigerator temperature (about
5°C).
• If“Energysaving”modeisenabled,youmayhavetowait
a few seconds before the drink is delivered.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (g. 21).
4. Replace the lid on the milk container and press down-
wards until it clicks in place.
5. Extract the hot water spout by pressing the button on the
spout (g. 22A)
6. Attach the milk container to the nozzle and push as far as
it will go (g. 23). The machine emits a beep (if the beep
function is enabled).
7. Placeasucientlylargecupunderthecoeeandfrothed
milk spouts. Adjust the length of the milk spout. To move
it nearer the cup, simply pull it downwards (g. 24).
8. Follow the instructions below for each function.
Adjusting the amount of froth
Turn the froth adjustment dial to adjust the amount of froth
on the milk delivered while making cappuccino and milk based
coees.
Dial
position
Description Recommended for…
 previous next