Filter
Top Products
Operating instructions
33
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation. All buttons are
inoperative except for the On/Off button and a combination of
indicator lights, as indicated in the following chart, are flashing. Open
the dishwasher’s door and carry out the following suggested corrective
actions.
- Indicator light of the
programme in progress
is flashing.
- 1 flash of the indicator
light "End of
programme".
The machine does not fill
with water
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean out the sink spigot.The sink spigot is blocked.
Check the water drain
hose connection.
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
Check the water inlet hose
connection.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Fault code / Malfunction Possible cause Solutions
- Indicator light of the
programme in progress
is flashing.
- 2 flashes of the
indicator light "End of
programme".
The dishwasher will not
drain
Close the water tap and
contact the Service Force
Centre.
Protection against flooding is
active.
- Indicator light of the
programme in progress
is flashing.
- 3 flashes of the
indicator light "End of
programme".
152963010en per uk.qxp 25/03/2004 15.31 Pagina 33