Filter
Top Products
Installation instructions
42
Water inlet hose with safety valve
After connecting the double-walled water inlet hose, the safety valve
is next to the tap. Therefore the water inlet hose is only under pressure
while the water is running. If the water inlet hose starts to leak during
this operation, the safety valve cuts off the running water.
Please take care when installing the water inlet hose:
- The electrical cable for the safety valve is in the double-walled
water inlet hose. Do not immerse the water inlet hose or the safety
valve in water.
- If water inlet hose or the safety valve is damaged, remove the mains
plug immediately.
- A water inlet hose with safety valve must only be replaced by a
Service Force Engineer.
- Place the water inlet hose in such a way that it is never higher than
the bottom edge of the safety valve.
- The water inlet hose must hang vertically down from the water
supply tap.
152963010en per uk.qxp 25/03/2004 15.31 Pagina 42