Filter
Top Products
Installation instructions
40
Installation instructions
Any electrical and/or plumbing work required to install this
appliance should be carried out by a qualified electrician and/or
plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close
fitting sink unit or a pre-existing top, providing the dimensions of the
recess correspond to those shown in the picture.
Proceed as follows:
Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull the worktop from the back
of the machine and slide out the front
slots, lifting the worktop.
Insert the machine after adjusting height
and levelling with the adjustable feet.
When inserting the machine, ensure that
the water inlet and drain hoses are not
kinked or squashed.
During all operations that involve accessibility to internal components
the dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily
accessible for the Service Force Engineer.
If the dishwasher is later used as a free-standing appliance, the
original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on
either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable
feet until the machine is perfectly level.
820
450
570
÷
600
IN04
152963010en per uk.qxp 25/03/2004 15.31 Pagina 40