Filter
Top Products
37
• To avoid possible burns use care when
opening the oven door after the Self-Cleaning
cycle. Stand to the side of the oven when
opening the door to allow hot air or steam to
escape.
• DO NOT force the oven door open. This can
damage the automatic door locking system.
Use caution and avoid possible burns when
opening the door after the Self-Cleaning cycle
has completed. The oven may still be VERY
HOT.
Setting self-clean
The SELF CLEAN pad controls the Self-Cleaning
feature. When used with a the Delay Start pad,
a delayed Self-Cleaning cycle may also be
programmed. The Self Clean feature allows for any
Self-Cleaning cycle time from 2 (2:00) to 4 hours
(4:00). You may also choose the clean time in 1
minute increments (for example 2 hours and 50
minutes) by pressing the corresponding number
keypads.
If you are planning to use the oven directly after
a self-clean cycle remember to allow time for the
oven to cool down and the oven door to unlock.
This normally takes about one hour. So a 3 hour
self-clean cycle will actually take about 4 hours to
complete.
*It is recommend to use a 2 hour self-clean cycle
for light soils, a 3 hour cycle for average soils,
and a 4 hour cycle for heavy soils (to assure
satisfactory results).
See example below to start an immediate Self-
Cleaning cycle or to set a Delay Start time of
8:00 o’clock and shut-off automatically (example
provided is a default 3 hour Self-Clean cycle)
Example
Step Press
1. Be sure the clock is set with the correct time
of day, the oven is EMPTY and the oven door
is closed.
2. Press SELF CLEAN
The control will automatically clean for a 3 hour
period (default self-cleaning cycle time). Note: If a
2 or 4 hour clean time is desired, press 2 0 0 for 2
hour or press 4 0 0 for a 4 hour clean time. Set the
cleaning time based on the amount of soil: light,
medium or heavy (*See above).
Note: If the optional delay Self-Clean feature is
needed, fi nish steps 3-4.
3. Press DELAY START
4. Enter the desired Self-Clean
starting time using the number
pads 8 0 0.
5. Press START
Setting Self-Clean Cycle
NOTE
You may press CANCEL any time during the
cleaning process. After cancelling the self-clean
cycle, do not attempt to open the oven door until
the DOOR lock icon turns off.
NOTE
The kitchen area should be well ventilated using
an open window, ventilation fan or exhaust
hood during the Self-Clean cycle. This will help
eliminate the normal odors associated with the
Self-Clean cycle.
NOTE
Allow about 15 seconds for the oven door lock to
close.
As soon as the control is set, the motor driven
oven door lock will begin to close automatically.
Once the door has been locked the “DOOR
LOCKED” indicator light will stop fl ashing and
remain on.
The control will calculate forward from the set
start time to determine when the Self-Cleaning
cycle should end. The Self-Cleaning cycle will
turn on automatically at the set time.
IMPORTANT
• If a self-clean cycle was started but did not
fi nish due to a power failure, your oven may
not be completely cleaned. After power has
been restored and the oven door has unlocked,
set for another self-clean if needed.
• The oven will need to cool down before starting
another self-clean cycle. The oven controls will
force a delay of 4 hours between cycles.
When the Self-Clean Cycle is Completed
Once the oven has cooled down for approximately 1
HOUR, and the “DOOR LOCKED” icon is no longer
displayed, the oven door can then be opened.