Electrolux A02992401 Range User Manual


 
39
Care and Cleaning
Do not close the oven door until all the interior
oven racks are fully inserted and retracted to
the back of the oven.
Do not hit the glass with pots, pans, or any
other object. The oven door glass may break or
even break at a later time unexpectedly.
Scratching, hitting, jarring or stressing the oven
door glass may weaken its structure causing
an increased risk of breakage at a later time.
You may use a glass cleaner on the outside
of the oven door glass. Do not spray or allow
water or the cleaner to enter or drip down into
the oven door vents. Spray cleaner on cloth
rst and then wipe the oven door clean.
Do not use strong oven cleaners, powders or
any harsh abrasive cleaning materials on the
outside of the oven door or glass.
Never clean the oven door gasket. The oven
door gasket should always clean during the
Self-clean cycle.
Special door care instructions Changing oven lights
Be sure the range is unplugged and all parts
are COOL before replacing oven light. Wear
a leather-faced glove for protection against
possible broken glass or burns.
IMPORTANT
Most oven doors contain glass that can break.
Read the following recommendations:
To replace the light bulb:
Replacing the Round Halogen Oven Light:
1. Turn the power off at the main source or
unplug the appliance.
2. The bulb is covered with a glass shield
screwed in place ( g. 1). Replace bulb with
25-watt halogen appliance bulb only ( g. 2).
Please note: do not allow your ngers to
touch the new bulb when replacing. This
will shorten the life of the new bulb. Use
a paper towel to cover the new bulb when
installing.
3. Replace the glass
shield ( g.1).
The glass shield
must be in place
whenever the
oven is in use.
4. Turn power back on
again at the main
source (or plug the
appliance back in).
5. The clock will then
need to be reset.
Figure 1 - Glass shield
removal
Figure 2 - Pull bulb out.
The oven lights will automatically turn ON when
the oven door is opened. The oven lights may also
be manually operated by pressing the
pad.
The oven light bulb is covered with a glass shield.
The glass shield can be removed to be cleaned
manually or to change oven light. THIS GLASS
SHIELD MUST BE IN PLACE WHENEVER THE
OVEN IS IN USE.