Filter
Top Products
40
L
O
C
K
Care and Cleaning
Removing and Replacing the
Oven Door
The oven door is heavy. Be careful when
removing and lifting the door. Do not lift the oven
door by the handle.
IMPORTANT
Most oven doors contain glass that can break.
Read the following recommendations:
• Do not close the oven door until all the interior
oven racks are fully inserted and retracted to
the back of the oven.
• Do not hit the glass with pots, pans, or any
other object. The oven door glass may break or
even break at a later time unexpectedly.
• Scratching, hitting, jarring or stressing the oven
door glass may weaken its structure causing an
increased risk of breakage at a later time.
• You may use a glass cleaner on the outside
of the oven door glass. Do not spray or allow
water or the cleaner to enter or drip down into
the oven door vents. Spray cleaner on cloth fi rst
and then wipe the oven door clean.
• Do not use strong oven cleaners, powders or
any harsh abrasive cleaning materials on the
outside of the oven door or glass.
• Never clean the oven door gasket. The oven
door gasket should always clean during the
Self-clean cycle.
Door Hinge
locations
with oven door
fully open
Figure 1
Figure 2
Figure 3
Oven door
Around
Hinge
To Remove Oven Door:
1. Open oven door completely (horizontal with
fl oor - See Figure 1).
2. Pull the door hinge locks on both left and
right door hinges down from the oven frame
completely towards the oven door (See Figure
2). A tool such as a small fl at-blade screwdriver
may be required.
3. Firmly grasp both sides of oven door along the
door sides (Do not use the oven door handle -
See Figure 3).
4. Close the door to the broil stop position (the
oven door will stop into this position just before
fully closing).
5. With the oven door in the broil stop position, lift
the oven door hinge arms over the roller pins
located on each side of the oven frame (See
Figure 4).
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the
door sides (Do not use the oven door handle -
See Figure 3).
2. Holding the oven door at the same angle as
the removal position, seat the hook of the hinge
arm onto the roller pins located on each side of
the oven door frame (See Fig. 4). Also, seat the
notch of the hinge arm onto the bottom of the
slot at the same time you seat the hook. The
hook and notch of the hinge arms must be fully
seated onto the roller pins and bottom of the
slot.
3. Fully open the oven door (horizontal with fl oor -
See Figure 1).
4. Push the door hinge locks up towards and into
the oven frame on both left and right oven door
hinges (See Figure 2) to the locked position.
5. Close the oven door.