Filter
Top Products
Solutions to Common Problems
63
Problem
Surface cooking zone does not heat
evenly.
Cooking zones do not glow red when
heating cookware.
Oven control panel beeps & displays
any F code error.
Oven control panel beeps & cooktop
control displays any E code error.
Self-clean cycle will not start.
Soil not completely removed after
finishing self-cleaning cycle.
Solution
Lightweight or warped pans used. Use only flat, evenly
balanced, medium or heavyweight quality cookware. Flat
pans heat better than warped pans. Cookware materials
and weight of the material affect heating. Heavy &
medium-weight pans heat more evenly. Because
lightweight pans heat unevenly, foods may burn easily.
The induction cooking zones will not glow when they are
heating. Induction cooking uses electromagnetic energy
to induce heat directly to the cookware on the cooktop.
Oven control has detected a fault condition. Press
CANCEL to clear the display & stop beeping. Try the
bake or broil feature again. If the F code error repeats,
remove power supply from appliance, wait 5 minutes
and then repower the appliance and set clock for the
time of day. Try the bake or broil feature again. If the
fault recurs, record fault number and call for service.
The cooktop control has detected a fault or error
condition. If the E code error persists, turn off any
active cooking zones. Remove power supply from
appliance, wait 5 minutes and then repower the
appliance and set clock for time of day. Try the
cooktop setting again. If the error recurs, record E code
error number and call for service.
Oven racks not removed or oven control not set
properly. Follow instructions under Self-cleaning.
Self-cleaning cycle was interrupted. Follow steps under
"Stopping or interrupting a self-cleaning cycle" under
Self-Cleaning.
Excessive spillovers on oven bottom. Remove before
starting self-clean.
Failure to clean bottom, front top of oven, frame of oven
or door area outside oven seal. These areas are not in
the self-cleaning area, but get hot enough to burn on
residue. Clean these areas before the self-cleaning cycle
is started. Burned-on residue can be cleaned with a stiff
nylon brush and water or a nylon scrubber. Be careful
not to damage the oven door gasket.