Filter
Top Products
NOTES
35
280
FLEXIBLE PIPE INSTALLATION
FITTING THE APPLIANCE AND CABINET
It is recommended that a
3/8”, 1100mm long angled
flexible hose (BFS), and a ½
” straight socket (BFS) be
used for the installation. However, any approved hose
of the right length can be used.
IMPORTANT: Flexible tubing used must comply with
BS 669 current editions. L.P.G. flexible connections
must be of a type suitable for L.P.G. and capable of
operation up to 50mbar and carry a red stripe, band or
label.
NOTE: Only liquid sealants can be used in threaded
gas connections. Do Not use P.T.F.E.Tape.
1. Make suitable arrangements for gas and electric
supplies into the installation site.
2. When unpacking the appliance keep it on its
polystyrene base until it is put into the cabinet to
avoid damage.
NOTE: It is imperative that the appliance is left
in the base to protect both the appliance and the
floor.
3. If the gas supply bayonet and wall fixing bracket are
to be located behind the appliance it must be
located in the shaded area as indicated in Fig.8.
4. Connect flexible hose to the gas inlet supply block
see Fig.8. The hose should be long enough to allow
the appliance to be withdrawn from the cabinet.
5. Position the appliance in front of the cabinent and
run the supply cable (See Connection to Electricity
Supply) through the cabinet and connect to the
junction box or socket. Ensure that the supply is
isolated at this stage. Connect flexible hose to the
bayonet connector.
INSTALLATION INSTRUCTIONS
120
Fig.8
120
580
280