Filter
Top Products
NOTES
36
CONNECTION TO ELECTRICITY SUPPLY
WARNING: This appliance must be earthed,
do not earth this appliance to the gas supply
piping.
This appliance must be connected to a isolated 230V-
240V a.c. 50Hz supply which incorporates a 3 ampere
fuse. If any other tyre of plug is used it should
incorporate a 5 ampere fuse in either the plug or adapter
or at the distribution board. The appliance is supply with
2 metres (6.5 ft) of 5 ampere 3 core cable fitted with a
moulded plug. Ensure the plug is accessible to the user.
If this proves insufficient to allow the appliance to be
plugged into the nearest supply socket, the supply cable
can be either extended by using a B.E.A.B. approved 3-
way sealed flex connector with integral flex clamps.
DO NOT EXTEND THE CABLE USING PLASTIC OR
CERAMIC CONNECTION TERMINAL BLOCKS
AND/OR INSULATION TAPE.
Should the supplied cable be required to be threaded
through small apertures in the cabinets it can be
removed from the mains plug.
If the supplied moulded plug is cut off dispose of it
safely as it will be a shock hazard if inserted into a
13 amp socket elsewhere in the house.
To fit a 3 pin 13 amp plug to the end of the appliance
cable (Fig.9.). Connect the wires as follows:
BROWN to live terminal.
BLUE to the neutral terminal.
GREEN / YELLOW to the earth terminal.
INSTALLATION INSTRUCTIONS
Fig.9.