Filter
Top Products
9
Gas supply
The gas connection must be carried out by an authorised person according to the relevant
standards.
Before connecting the appliance to the gas main, mount the brass conical adaptor onto the
gas inlet pipe, upon which the gasket has been placed (see Fig.s following).
Conical adaptor and gasket are supplied with the appliance (packed with conversion kit for
use with Natural gas or Propane gas).
This appliance is suitable for use with Natural gas or Propane gas. (Check the “gas type”
sticker attached to the appliance).
For Natural gas models, the gas supply is connected to the pressure regulator which is
supplied with the appliance. Adjust the regulator to obtain a test point pressure of 1 kPa
with the two semi-rapid burners operating at the maximum.
For Propane gas models, the gas supply is connected to the test point adaptor which is
supplied with the appliance. Ensure that the supply pressure is regulated to 2.75 kPa.
The connection must be made at the rear of appliance (left or right); the pipe is not to
cross the cooker.
Close off the unused inlet with the cap and sealing gasket supplied (Fig. 8).
IMPORTANT: Use two spanners to tighten or loosen the connecting pipe, as shown
following.
Installation instructions
Fig. 5 Propane gas connection Fig. 6 Natural gas connection
Gas connection for
PROPANE GAS
Gas connection for
NATURAL GAS
Gas inlet pipe
Nipple
Gasket
Brass conical adaptor
(Thread tight: use
suitable seal)
Gas inlet pipe
Nipple
Gasket
Brass conical adaptor
(Thread tight: use
suitable seal)
Gas regulator
Test point adaptor
Test
point
Test point