Filter
Top Products
3
Safety and warnings
A suitable disconnection switch must be incorporated in the permanent wiring, mounted
and positioned to comply with the local wiring rules and regulations. The switch must
be of an approved type installed in the fixed wiring and provide a 3 mm air gap contact
separation in all poles in accordance with the local wiring rules.
In Australia and New Zealand, a switch of the approved type with a 3 mm air gap must be
installed in the active (phase) conductor of the fixed wiring.
The switch must always be accessible.
The power supply cable must not touch any hot parts and must be positioned so that it does
not exceed 75 °C at any point.
To connect the cooker to the mains, do not use adapters, reducers or branching devices as
they can cause overheating and burning.
This cooker must be connected to a suitable double pole control unit adjacent to the cooker.
No diversity can be applied to this control unit.
If the electrical supply cord is damaged, it must only be replaced by an authorised person.
This cooker must be connected to electrical supply using V105 insulated cable.
The cooker must be earthed.
Voltage and power consumption
220-240 V~ 50 Hz 3100 W