52
Troubleshooting
Problem Possible causes What to do
Self Clean function
During a Self Clean
cycle, the oven is louder
than usual.
This is normal: the oven’s cooling fans operate at their highest speed.
The display shows - -
The meat probe mode has been
selected but the meat probe is not
plugged in to the socket.
Ensure the meat probe is
plugged into the socket.
Cancel meat probe by pressing
the cancel
button.
The display shows DOOR. The door has not been properly
closed.
Make sure you close the door
properly.
The display shows
0:00 but the oven door
will not open.
The oven door is locked because
the oven is still too hot to be used
for cooking.
Wait until the Self Clean cycle
has finished. If you cancelled a
Self Clean cycle which was
already underway, the oven
still needs to cool down before
it can be used. The oven door
will automatically unlock.
At a point during a Self
Clean cycle, the function
dial halo goes out
and the temperature
indicator starts
displaying cascading
bars
.
This is normal: the oven is
in the last phase of the Self
Clean cycle, cooling down.
Wait until the Self Clean cycle
has finished. A long tone will
sound and the oven door will
automatically unlock when the
oven is ready to use.
Double oven models only:
I cannot select the Self
clean function.
One oven is already turned on or
set for automatic cooking.
You cannot start a Self Clean
cycle when one oven already
has a function selected.
Turn the function dial to Off
and try again.