Filter
Top Products
4-17
DANGER
When draining oil into an appropriate METAL container, make sure the container will
hold at least FOUR gallons (15 liters) or more, otherwise hot liquid could overflow
and cause injury.
The computer displays INSERT DISPOSAL UNIT. Once the filter pan is removed the
computer displays alternating with IS DISPOSE UNIT IN PLACE? and YES NO.
6. With the MSDU or a METAL container with a capacity of FOUR gallons
(15 liters) or larger is in place, press the (1 yes) button to continue.
The heating source is disabled, the drain valve opens and the computer displays disposing for
20 seconds.
The drain valve remains open and the computer displays Vat empty?
alternating with yes.
7. With the vat empty, press the (1 yes) button to continue .
The computer displays cln vat Complete? alternating with YES.
8. Clean the vat with a scrub brush and when complete press the (1 yes)
button to continue.
The drain valve closes and the vat is ready to be refilled with oil. Continue to next section if fryer is
set to JIB.
4.10.4.2 Refilling JIB Oil Systems
JIB (Jug In Box) oil systems use oil stored in boxed jugs inside the fryer cabinet.
If the oil system was set to JIB during initial setup, the computer displays manual fill VAT
alternating with YES.
1. Carefully pour oil into the pot until it reaches the low fill line in the fryer.
2. Press the (1 yes) button when vat is full.
The computer displays off.
4.10.4.3 Draining and Disposing Oil using Bulk Oil Systems
Bulk oil systems use a pump to move exhausted oil from the fryer to a holding tank. Additional
plumbing is used to connect the bulk oil systems to the fryers.
WARNING
Ensure a filter pad is in place prior to draining or disposing of oil. Failure to insert a
filter pad may result in clogged lines and/or pumps.