Filter
Top Products
C141-E124-01EN3 - 96
(4) Defect processing during initialization
Table 3.5 shows each combination of control flag specification values and the contents of
processing executed by the IDD. Furthermore, see Chapter 3 “Data Format” of the “Product
Manual” concerning alternate block allocation processing methods.
Table 3.5 FORMAT UNIT command defect processing (1 of 2)
CDB Byte 1 Header
FmtData CmpLst Defect
List
Format
FOV DPRY Defect
List
Length
Defect Processing Method
0 –
(Note 4)
– – – (Format parameters not
transferred)
c Alternate block allocation is
performed for defects registered in
the P List.
d The previously existing G List is
erased.
1 0
(Note 1,
Note 2,
Note 3)
d d d 0
1
0
0
Zero
c Alternate block allocation is
performed for defects registered in
the P List and the previously
existing G List.
d The previously existing G List is
saved.
1 0
(Note 1,
Note 2,
Note 3)
d d d
1 1 Zero
c Alternate block allocation is
performed for defects registered in
the previously existing G List.
d The P List is saved, but it is not
used in defect processing.
e The previously existing G List is
saved.
1 1
(Note 1,
Note 2)
d d d 0
1
0
0
Zero
c Alternate block allocation is
performed for defects registered in
the P List.
d The previously existing G List is
erased and it is not used in defect
processing.
1 1
(Note 1,
Note 2)
d d d 1 1 Zero
c Neither the P List or the G List is
used in defect processing
(alternate block allocation
processing is not performed.)
d The P List is saved, but the
previously existing G List is
erased.
1 0
(Note 3)
1 0 0
1 0 1
0
1
0
0
>0
c Alternate block allocation is
performed for defects registered in
the P List, in the previously existing
G List and the defects described in
the D List transferred from the
INIT.
d The D List is added to the
previously existing G List.