Filter
Top Products
C141-E124-01EN 4 - 13
held as is and those values are reported in response to a MODE SENSE or MODE
SENSE EXTENDED command. (Rounding processing of the parameters is not done by
the IDD.)
c. Bus inactivity limit
This parameter indicates the maximum time that the TARG is permitted to keep the SCSI bus
in the busy state (BSY signal = TRUE) without executing a REQ/ACK handshake, in multiples
of 100 Ps. In the IDD, this value is 100 Ps during normal operation. It is impossible for this
parameter to be changed by the INIT. The IDD disregards the value specified in this
parameter and operates according to the "Default" value.
d. Disconnect time limit
This parameter specifies the maximum time that the TARG is permitted to continue in the
disconnect state until it starts reconnect processing, in multiples of 100 Ps.
In the IDD, this value is 0 Ps. It is impossible for this parameter to be changed by the INIT.
The IDD disregards the value specified in this parameter and operates according to the
"Default" value.
e Connect time limit
This parameter specifies the maximum time that the TARG is permitted to use the SCSI bus
until it starts disconnect processing, in multiples of 100 Ps.
In the IDD, this value is unlimited. It is impossible for this parameter to be changed by the
INIT. The IDD disregards the value specified in this parameter and operates according to the
"Default" value.
f. Maximum burst size
This parameter specifies the maximum volume of data the TARG is permitted to transfer
continuously in the DATA IN phase or the DATA OUT phase until it starts disconnect
processing, in multiples of number of bytes per sector.
In the IDD, this value is unlimited. It is impossible for this parameter to be changed by the
INIT. The IDD disregards the value specified in this parameter and operates according to the
"Default" value.
g. Data transfer disconnect control (DTDC)
DTDC: Controls how to perform disconnection.
00b= Perform disconnection according to the instructions of other parameters without
using DTDC.
01b= When a data transfer by the command is started, the target will never try
disconnection until transmission of all the data to be transferred by the