Filter
Top Products
15
Table 8 - Performa 960 FA Level II Programming Parameters
Parameter
Range of Values
Minimum
Increments
Default Units of Measure Notes
Name Description
P6 Refill controller 1 to 99 1 33
Must be set to 46 for Performa 960
FA operation
P7
Regenerant draw
value
1 to 99 1 25
Select Regenerant Draw value from
Table 9 and enter that number.
P8 Not used NA NA NA NA NA
P9 Backwash time 3 to 30 1 14 Minutes
Skip this parameter to accept the
default or enter a value.
P10 Slow Rinse time 8 to 125 1 40 Minutes
Skip this parameter to accept the
default or enter a value.
P11 Fast Rinse time 2 to 19 1 4 Minutes
Skip this parameter to accept the
default or enter a value.
P12 Units of measure 0 to 1 1 0
0 = U.S., 1 = Metric. Skip this
parameter to accept U.S. or enter 1
for Metric.
P13 Clock mode 0 to 1 1 0
0 = 12-hour clock, 1 = 24-hour
clock. Skip this parameter for a 12-
hour clock or enter 1 for a
24-hour clock.
P14
Calendar
override
0 to 30 1 0 Days
0 = no calendar override. Skip this
parameter for no calendar override
or enter a value.
P15 Reserve type 0 to 3 1 0
0 = variable reserve, 1 = fixed
reserve, 2 = variable reserve with
immediate regen, 3 = fixed reserve
with immediate regen. Skip this
parameter to accept the default or
enter a different reserve type.
P16
Fixed reserve
capacity or initial
average value
0 to 70 1 30 Percent of capacity
Description depends on the value
entered for P15. Skip this
parameter to accept the default or
enter a different value.
P17 Operation type 0 to 2 1 2 2 = 5 cycle Cocurrent conditioner
P18
Regen. Dosage/
Capacity change
lock out
0 to 1 1 0
0 = none, 1 = Regenerant Dosage/
Capacity change locked out. Skip
this parameter to accept the
default or enter 1 to lock out
Regenerant Dosage/Capacity
change.
P19 Factory defaults 0 to 3 1 99
Loads in factory default values. Do
not change this parameter.