Filter
Top Products
Rev. May 2001 GraviMaster-FGB-M05 (S) Page 36
Gravimetric Blender
3.6 Reports and overviews
There is the possibility of printing several reports and overviews. Underneath a list is made
with the reports and overviews with behind them the section and page where instructions for
printing are given.
* batch report § 3.5.1
* production report § 3.5.1
* material usage report § 3.3.2
* error report § 3.5.1
* recipe overview § 3.2.2
* component overview § 3.2.1
* alarm overview § 5.1
3.7 Settings of the user-interface
3.7.1 Change the rights of an operator
The terminal has some area’s which are protected by a password; protected-parameters, debug-
monitor etc. Before an operator can use, modify or see these area’s he has to perform a login
procedure. This procedure starts by choosing menu (F1) ‘system / login’ the controllers asks
now for an ID (see below). When the ID is correct the menu item login changes to logout.
To lock the system select menu (F1) ‘system / logout’ the menu item changes to login again.
3.7.2 Change entrycode
To change ID chose menu (F1) ‘system / change ID’.
IMPORTANT
Standard the ID is set to 1234. After it is changed the ID 1234 can’t be used.
There is no way to display the current ID so store the actual ID in a safe place.
When you lost the new code, please contact your dealer.