Filter
Top Products
L
I \\ ei
1
To replace hood lamp, first disconnect power at
main fuse or circuit breaker panel or
pull plug.
Remove 2 screws from each side of lower panel and
3 screws from front edge. Lower panel until it rests
on range below. Be sure bulb to be replaced is cool
before removing. Remove bulb or bulbs and replace
with 40 watt appliance bulbs. Raise lower panel and
replace screws. Connect electrical power to micro-
wave oven.
Fa+-
To replace your oven lamp, first disconnect power at
main fuse or circuit breaker or pull plug. Remove the
top grill by taking off
2 screws which hold it in place.
Next, remove the single screw on top left that
secures lamp housing. (On models so equipped.)
Open oven door for easier removal of the lamp hous-
ing assembly. Then grasp tab and pull out and up to
clear door hinge and front lip of oven. To remove
bulb, push it inward gently
and turn to left, then pull
outward from socket.
Replace with GE Lamp
#
25T8DC.
Clean off the grease and dust on
hood surfaces
often. Use a warm detergent solution. About 1 table-
spoon of ammonia may be added to the water. Take
care not to touch the filters and enameled surfaces
with this. Ammonia will tend to darken metal.
% not attempt to operate the oven unless the grill is
place.
90
La
.—..