Filter
Top Products
16
4
Connect
Electrical
Step
3
Connect
Ductwork
Step
JXRB57 Kit
For Indoor Remote Blower Locations
Duct Adapter
Outlet Cover
Downdraft
• The downdraft plenum can discharge from
either the right or left side. Select the side
that provides the best alignment to ductwork
extending to the blower assembly below.
– For a left side discharge, install the outlet
plate to the bottom of the plenum on the
left side. Install the cover plate to the
bottom of the right side. Reverse plates for
a right side discharge.
.
• Connect the plenum to the ductwork.
A transition is required to connect the
3-1/4" x 10" duct to the 6" round inlet on
the blower.
• Tape to seal all joints.
• Use electrical cable and connectors that
conform to local codes (14 gauge min. is
recommended). Use a length to reach
between the vent and the blower/motor
location.
• Attach the wire box removed from the
blower conduit to the end of new wiring.
• Use wire nuts to secure the wire to the 3"
remaining wires with plug.
• Insert the plug into the mating plug on the
vent.
• Reinstall wire box with original screws.
• Install a junction box withing reach of the
blower conduit.
• Use a conduit fitting to secure conduit to
junction box. The red plastic anti-short
bushing should be secured to the end of the
conduit.
• Use wire nuts to connect wires.
Wiring to Blower Junction Box
Provided
Mounting
Screws
Blower
Wire
Box
Wire Nuts
3-Wire
Connectors
Plenum