Filter
Top Products
Parts
36 3A0237L
15F144 Hose Wire Jumper
Use the 15F144 Hose Wire Jumper to heat only the
major volume hose, in a wide ratio system.
To build one complete 50 ft single side heated hose bun-
dle, order the following parts:
Install as follows:
1. Wrap hose wire jumper (100) around resin hose
(101) in a spiral fashion.
2. Connect resin hose wire (101a) to other side of
Power-Lock
™
connector (100a); see page 16.
3. Wrap FTS cable (102) around resin hose (101) in a
spiral fashion.
4. Twist hoses (101 and 105) together to provide strain
relief.
5. Repeat steps 1-4 for each length of hose (101).
Connect hoses, electrical connectors, and cables;
see , page 16.
6. Install one -Lock connector (100a) between wires;
see page 17.
7. Connect 258758, page 20.
8. Install whip hose and gun. Ensure that gun is
grounded.
9. Connect hoses to proportioner.
10. Insulate and protect hoses. See Protective Cover-
ing, page 22.
Ref. Part Description Qty
100 15F144 JUMPER, hose wire; includes
two 117789 electrical connec-
tors; 50 ft (15.2 m) long
1
101 chart 2,
page 36
HOSE, resin, heated; 50 ft (15.2
m) minimum
1
102 15B296 CABLE, FTS 1
103 15C517 HARNESS, hose jumper 1
104 261670 FLUID TEMPERATURE
SENSOR
1
105 pur-
chase
locally
HOSE, hardener, unheated; 50
ft (15.2 m) minimum; customer
supplied
1
106 pur-
chase
locally
CONNECTORS, fluid; as
required to complete assembly;
not shown
as
req’d
Hoses (101 and 105) must be sized and pressure
rated to meet the requirements of your system.
Do not operate heated hose (101) at more than 45 A.
If hose is cold, turn current adjustment fully counter-
clockwise before reheating hose.
Spray gun must be grounded.
105
TI14739a
100a
102
100
100
100a
101a
101a
101
FTS