Filter
Top Products
-12-
Model G0770 (Mfd Since 11/13)
Te st Ru n
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly setup machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
Test run the saw to ensure it is properly connected
to power and operates correctly.
If you find an unusual problem during the test
run, immediately stop the saw, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
To test run the meat saw:
1. DISCONNECT SAW FROM POWER!
2. Rotate both wheel cover knobs (see Page 3)
clockwise to open wheel cover and expose
wheels.
3. Make sure of the following blade conditions
(see Figures 3–4 for identification):
• Blade teeth face down through table.
• Blade is within
1
⁄64" of wheel back lip on
both wheels.
• Blade is properly positioned between blade
guide and against blade wipers.
Figure 4. Bottom wheel blade wipers.
Blade
Wiper
Blade Wiper
Figure 3. Top wheel blade.
Wheel
Back Lip
Blade Guide
Blade
Wipers