Filter
Top Products
-18-
Model G0770 (Mfd Since 11/13)
5. Remove scrap tray from wheel cover (see
Figure 11), then lift wheel cover off hinges.
6. Remove largest particles of meat/bone and
place into a garbage container.
7. Using hot water, rinse and wipe away as
much leftover material as possible.
8. Clean sink compartments with hot water and
dish soap, then rinse them thoroughly with
hot water.
Note: Dishwashers are a good option for
cleaning AND sanitizing at the same time
because they use heat. Place the parts
that can fit inside the dishwasher and use
the highest possible heat settings. If it is an
option, use the dishwasher to dry parts with
hot air.
9. Fill a clean sink compartment with hot, soapy
water.
10. Submerge the removed parts in the soapy
water and scrub all surfaces thoroughly.
11. Rinse all parts with clean hot water until all
visible suds are removed.
Note: If the soapy water becomes hazy, drain
the compartment and refill with more hot,
soapy water.
12. Clean all other surfaces of saw body with a
cloth rag and hot, soapy water. Afterward,
use hot, clear water and a clean cloth rag to
remove soapy residue.
13. Allow all parts and surfaces to air dry after
rinsing.
Figure 11. Wheel cover hinge and scrap tray
identification.
Hinge
(1 of 2)
Scrap Tray
To avoid damaging electrical parts when
reconnecting saw to power, do not spray
saw body with water or solutions. Do not
allow any liquid to enter the side vents
around the motor. Instead, use a cloth rag
and hot, soapy water to thoroughly clean
the surfaces of the saw body.