Filter
Top Products
English
14
5. Disconnect the air line from the CO2 cylinder.
6. Remove the CO
2 cylinder from the cabinet.
7. Remove the beer tower from the cabinet by grasping the center of the tower.
Turn counterclockwise and lift.
8. Pull the beer line through the top of the cabinet.
9. Install the cabinet plug on the worktop.
10. Lay the unit down sideways. We recommend that you place a piece of
cardboard or cloth underneath the cabinet to avoid dents or scratches to the
cabinet. Remove the casters and install leveling legs.
11. Install the two wire shelves.
A. Insert one end of each support pin into the holes on the right side of the
cabinet.
B. Place one end of the wire shelf into the left side of the cabinet and rest the
other end onto the exposed support pins on the right side.
C. Repeat the same with the second shelf.
12. The conversion process is now complete. Store all the removed accessories in a
safe place for future use.
13. Adjust the temperature of the unit as required for food storage.
Follow the energy-saving tips below for optimum efficiency.
• Limit the opening and closing of the door on hot and humid days. When you
open the door, close it quickly to prevent hot air from entering.
• Check regularly for proper air circulation around the unit to make sure that the
unit receives sufficient airflow.
• Keep the door gasket clean and pliable to ensure a proper seal. If the door gasket
is not sealed properly, hot air may easily enter into the unit, making the interior
temperature warmer. The compressor must then run continuously to keep the unit
cool, thus making the energy consumption very high and inefficient.
Note: Replace a damaged door gasket to restore energy efficiency.
• DO NOT store hot food in the unit. Let the food cool before refrigerating it.
Energy Saving Tips