Filter
Top Products
– 6 –
SCRAP TRAY
During use, the scrap tray should be installed
between the left-hand table and the carriage
support (Fig. 9). The scrap tray slides into place,
resting on the frame between the carriage support
and table. The angled side of the scrap tray is
located nearest the blade.
Fig. 9
CARRIAGE
In use, the carriage can roll back and forth between the left carriage stop (Fig. 10) and the right carriage
stop, assuming the spring loaded carriage lock (Fig. 5) has not locked the carriage in a stationary
position.
To remove the carriage, turn either of the carriage stops 90 degrees so the bumper is toward the rear
(Fig. 11). Roll the carriage off either end while lifting it free of the carriage support structure (Fig. 10).
To reinstall the carriage, hold the carriage so the bearings (underneath) are aligned with the carriage
support structure. Roll the carriage into place. Return the carriage stops so the carriage is stopped
at both ends.
Fig. 10 Fig. 11
PL-41393-1
CARRIAGE
RIGHT TABLE
UPPER GUIDE AND GUARD
LEFT TABLE
LEFT
CARRIAGE
STOP
CARRIAGE
SUPPORT
LEFT CARRIAGE STOP
WITH BUMPER TOWARDS
THE REAR
PL-41394-1
PL-41392-1
SCRAP TRAY
6801 Meat Saw Technical Manual Page 12 of 51