Filter
Top Products
– 12 –
MAINTENANCE
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING THE CIRCUIT IS BEING WORKED ON.
LUBRICATION
The motor has permanently lubricated ball bearings and requires no additional lubrication.
The slide bar for the upper guide and guard assembly also requires no lubrication.
After cleaning, apply a small amount of mineral oil to the six ball bearing rollers underneath the
carriage, to the gauge plate slide rod, and to the pulley shafts.
CHANGING SAW BLADES
If changing saw blades, disassemble components as described in R
EMOVING THE BLADE, page 7, and the
instructions for any component throughout the manual. Make sure wipers, scrapers, and all other
components are properly reassembled. Refer to B
LADE TENSION, page 7. Refer to LOWER BLADE GUIDE,
page 7.
SERVICE
Contact your local Hobart Service Office for any repairs or adjustments needed on this equipment.
FORM 34405 Rev. B (Sept. 2001) PRINTED IN U.S.A.
6801 Meat Saw Technical Manual Page 18 of 51