Filter
Top Products
– 8 –
ELECTRICAL CONNECTIONS
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING THE CIRCUIT IS BEING WORKED ON.
ATADLACIRTCELE
ledoMesahP/ztreH/stloV
esuFrekaerBtiucriC
muminiM
yticapmAtiucriC
SPMA
mumixaM
eziSesuF
SPMA
muminiM
yticapmAtiucriC
SPMA
mumixaM
eziSrekaerBtiucriC
SPMA
1086
1/06/03252520303
3/06/032-00202020202
3/06/06451015151
.noitidetsetal,07APFN,edoClacirtcelElanoitaNehthtiwecnadroccanidelipmoC
A
7
/8" diameter hole for
1
/2" trade size conduit is located at the upper rear of the column. Use watertight
connections. Refer to Electrical Data, the machine data plate, and the wiring diagram located on the
machine when making the electrical connection. Connect the electrical power supply leads to the
pigtail leads; use copper wire rated at least 60°C for the connection.
CHECK MOTOR ROTATION (Three-Phase Machines)
If the motor does not rotate so the teeth of the saw blade run downward as you look at the cutting zone,
correct the rotation using the following procedure:
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.
Interchange any two of the incoming power supply leads. Reconnect the power supply and turn
the saw momentarily on and off to verify correct rotation.
CONTROL BOX HEATER
The meat saw has a heater in the control box to keep the controls dry. The heater is automatically ON
when the machine is electrically connected. The meat saw should be connected to the power supply
EXCEPT when performing assembly, disassembly, cleaning, or maintenance on the saw.
CLEAN SAW BEFORE USE
The saw must be thoroughly cleaned and sanitized after installation and before use. Refer to Cleaning,
page 11.
6801 Meat Saw Technical Manual Page 14 of 51