Filter
Top Products
– 19 –
Inspect Door Components
1. Verify door switch operation (Fig. 9).
A. Open door.
B. While watching the door switch (at top of oven), close the door.
C. The door switch should be operated.
D. With the door open, the switch should be un-operated.
2. Check loading door latch bushings.
A. Open door.
B. Inspect door latch bushings for wear. If the bushings are worn, contact your local
authorized Hobart office for service.
C. With the door closed, the gasket should provide an even seal and not let hot air or steam
escape from around the door.
3. Check door sweep.
A. The door sweep should contact the ramp approximately
1
/8" evenly across door width,
when door is in the closed position.
B. If door sweep needs replaced or adjusted, contact your local authorized Hobart office for
service.
Inspect Air Louvers
1. Check air louvers (Fig. 10) (shutters) inside oven and tighten any loose screws.
2. Check oven interior, tighten or replace loose or missing panel screws.
Fig. 9
Fig. 10