Filter
Top Products
– 27 –
DEFROSTING
COIL 12
°F
TIME REMAINING 19:52
EXIT
READY TO DEFROST
REMOVE FOOD
CANCEL START
DEFROST
NOT REQUIRED
HOLD PROD —
After Chilling or when selected, runs the chiller like a regular refrigerator.
From the Main Menu, select MORE and HOLD PROD.
(Temperatures are indicated for air and probes.)
(Timer indicates the run time. No printed reports are
available.)
(EXIT returns to the Main Menu; however, Hold mode
continues until another selection is made.)
DEFROST
NOTE: DEFROST starts automatically after 6 hours of chilling but only if
operating in Holding mode.
From the Main Menu, select MORE and DEFROST.
• To begin Defrosting, remove food and select START.
(CANCEL returns to the Main Menu.)
• The DEFROST cycle runs 20 minutes or until the Coil
Temperature reaches 50°F.
(EXIT returns to the Main Menu.)
• If DEFROST NOT REQUIRED is displayed, return to
Main Menu is automatic.
PRINT —
Once a chill cycle is done, data can be printed.
From the Main Menu, select MORE and PRINT.
• The last chill cycle displays Probe # (if BY TEMP),
MM/DD (month/day), and HH: mm (hour:minute).
Probe # will not display if the chill cycle was BY TIME.
• Select the Cycle you want to print by pressing ← (for
previous) and → (for next).
• Press PRINT.
(MAIN returns to the Main Menu.)
• To print, select RECORD, LABEL or BOTH. After
printing, the display returns to the Main Menu.
(NONE returns to the Main Menu.)
HOLDING AIR: 34°F
1 37
°F 37°F 3
2 37
°F 37°F 4
0:00:04 EXIT
MAIN MENU 08:05:01
BY TEMP BY PROD
BY TIME
MORE
MAIN MENU 08:06:01
HOLD PROD PRINT
DEFROST SETUP
BACK
PRINT PROBE #_
RECORD
LABEL
NONE BOTH
PRINT CYCLE #__
PROBE #_ MM/DD HH:mm→
←BACK SELECT NEXT→
MAIN MENU PRINT