Filter
Top Products
CLEANING THE BLOWER WHEEL
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A
TAG
AT
THE DISCONNECT
SWITCH
TO
INDICATE
THAT
YOU
ARE WORKING
ON
THE CIRCUIT.
Remove all racks
by
pulling forward, lifting
up
and out.
Remove both right and left rack supports
by
lifting
up.
Remove the blower baffle
by
lifting
up
and pulling out. Wash blower thoroughly with hot sudsy water using a sponge
or plastic web pad. Rinse with clean water and dry.
Replace the hardware
by
reversing the disassembly procedure.
CLEANING THE EXTERIOR OF YOUR OVEN
Wash
all exterior surfaces at least once daily using a cloth with warm water and a mild soap or detergent. Wjlere
surfaces have been waxed, use the cloth lightly - hard rubbing will remove polish. Follow with a clear rinse, then
dry.
This simple treatment will keep your equipment clean and sparkling, and eliminates the danger of grease
accumulation.
Permalucent Finish
If
grease has accumulated and attacked the PERMALUCENT finish, use
any
silicon-based polish following directions
on
the container. NEVER use a scouring pad
on
the PERMALUCENT finish.
If the surface is accidentally marred, it can
be
quickly and easily restored with a "PERMALUCENT Touch-Up Kit",
available through your Dealer. Full instructions are in each kit.
Cleaning Stainless Steel Surface
To
keep the stainless steel front spotless, clean regularly with a damp cloth and polish with a soft, dry cloth.
To
remove discolorations which may have formed when regular cleaning
was
neglected, use any detergent or plain
soap and water.
For
particularly stubborn discolorations, a self-soaping scouring pad may
be
used.
CAUTION: Always
rub
with the
"Grain"
in a horizontal direction.
Rinse, dry and polish with a soft cloth. Avoid using gritty soaps or harsh cleaners.
REPLACING LAMPS
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A
TAG
AT
THE DISCONNECT
SWITCH
TO
INDICATE
THAT
YOU
ARE WORKING
ON
THE CIRCUIT.
Remove all racks
by
pulling forward, lifting
up
and out.
Remove both the right and left rack supports
by
lifting
up.
Remove ten screws from the light window bezel.
Pull out the bezel and window.
Replace the bulb(s).
Replace the hardware
by
reversing the disassembly procedure.
-14-